- The 1-channel 5V control Single-Pole Double-Throw (SPDT) High-level trigger AC power relay board can be controlled directly via a microcontroller. It can switch up to 10A at 250 VAC. The inputs are isolated in order to protect any delicate control circuitry.
- Low level trigger mode | Pull down circuit to avoid malfunction | Triode drive | High impedance controller pin | Compliant with international safety standards | Power supply indicator lamp | Control indicator lamp | Indicator for relay output status
- LxWxH : 3.8 x 2.6 x 1.8 cm
- The 1-channel relay module can be used for microcontroller development board module or home appliance control. Never use a relay which exceeds the relay’s contact rating mentioned on the blocks.
- Number of channels : 1 Operating Temperature Range : -40 to 85 °C Switching Voltage(AC) : 250V@10A Switching Voltage(DC) : 30V@10A Trigger Current : 20 mA Trigger Voltage : 5 V(DC)
Specification: Robotbanao 5V Single Channel (1 Channel) Relay Module
|
4 reviews for Robotbanao 5V Single Channel (1 Channel) Relay Module
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review
Related Products
Robotbanao 5V Single Channel (1 Channel) Relay Module
₹300.00
VK –
Packaging is good. Product supplied needs more quality control. One of the two pieces (right side on the attached picture) had solder marks on the the 3-pin connector, and the red LED was missing altogether.
VK –
Very good product
Dharmendra –
The part sent was already used in some project. The pins were found soldered. Had to use the part as such due to urgency of project. However, it was impossible to fit jumper wires.
Gajanan Vaishnav –
Wasted a whole day due to this. Youtube video suggests that this product from China is faulty and never work and has to do some soldering