ASUS ROG Strix 27″ (69 cm) 2K HDR Gaming Monitor (XG27AQM) – WQHD (2560 x 1440 Pixels) Fast IPS, 270Hz, 0.5ms, Extreme Low Motion Blur Sync, G-SYNC…
₹25,689.00
- 27-inch WQHD (2560 x 1440) HDR gaming monitor with ultrafast 270Hz (overclocking) refresh rate designed for professional gamers and immersive gameplay
- ASUS Fast IPS technology enables a 0.5ms response time (GTG) for sharp gaming visuals with high frame rates
- ASUS Extreme Low Motion Blur Sync (ELMB SYNC) technology enables ELMB together with G-SYNC Compatible, eliminating ghosting and tearing for sharp gaming visuals with high frame rates
- High Dynamic Range (HDR) technology with professional color gamut delivers contrast and color performance that meets the DisplayHDR 400 certification
- G-SYNC Compatible, delivering a seamless, tear-free gaming experience
Specification: ASUS ROG Strix 27″ (69 cm) 2K HDR Gaming Monitor (XG27AQM) – WQHD (2560 x 1440 Pixels) Fast IPS, 270Hz, 0.5ms, Extreme Low Motion Blur Sync, G-SYNC…
|
6 reviews for ASUS ROG Strix 27″ (69 cm) 2K HDR Gaming Monitor (XG27AQM) – WQHD (2560 x 1440 Pixels) Fast IPS, 270Hz, 0.5ms, Extreme Low Motion Blur Sync, G-SYNC…
Show all
Most Helpful
Highest Rating
Lowest Rating
Add a review
Related Products
ASUS ROG Strix 27″ (69 cm) 2K HDR Gaming Monitor (XG27AQM) – WQHD (2560 x 1440 Pixels) Fast IPS, 270Hz, 0.5ms, Extreme Low Motion Blur Sync, G-SYNC…
₹25,689.00
Eli –
Few bullet points regarding the advertised features:
270hz:
-Had a few times where the monitor flickered, but I think it was due to the DisplayPort cable being an issue. I’m also using a dual monitor setup, this one and another with actual GSYNC module (PG27UQ). If I enabled Adaptive Sync on this monitor before turning on GSYNC in Nvidia’s control panel, this monitor sometimes went completely black and wouldn’t turn on unless I restarted the PC. But again, it’s possible this could be related to my dual monitor setup. So what I do from now on is just enable GSYNC in the Nvidia Control panel first, then enable Adaptive Sync on my monitor.
Monitor design:
-I really wished ASUS changed the design of the monitor ports for these monitors so the cables weren’t so bent going in. It goes up vertically and if your displayport is too bulky, the wires will get really bent going in. I’ve had to purchase separate ones, ones labeled “DisplayPort 1.4” from Maxonar Store on Amazon.
-Flickering @ 270hz stopped when I got the DisplayPort 1.4 cable. This is a different sort of screen-black-out that occurred without Adaptive sync turned on. Keep in mind there is a disclaimer when turning on 270hz that screen-flickering may occur. But so far, I’ve used it for 2 months now and havent had it happen after the week.
ELMB Sync
-I don’t use ELMB/GSYNC for competitive games, but I can confirm it does work fine. ‘
Just keep in mind that the following occurs when ELMB Sync is enabled:
-HDR can not be enabled
-Screen brightness is also dimmed as a result
-Overdrive setting is locked out when ONLY when ELMB Sync is enabled.. In other words, Adaptive Sync On + ELMB Sync off = Overdrive is unlocked. Adaptive Sync + ELMB Sync on = Overdrive is locked and cannot change.
You can technically also use only ELMB by turning on ELMB Sync on + Adaptive Sync Off. This is only advisable if the game is running at fixed FPS (120hz = game is constnatly 120fps, or 240hz = 240fps) If the game’s FPS fluctuates during this mode, you’ll experience double-images/artifacting.
Personally, I haven’t noticed any flickering/eye-strain with ELMB Sync, but as with strobe-based motion blur reduction, some people may be sensitive to it. ELMB sync will turn off by itself if it reaches below 80fps, FYI. It will turn back on once it goes back up. Someone also mentioned increasing brightness before turning on ELMB but it didn’t make a difference to me. The only thing you can change is Contrast and Shadow Boost levels with it on.
-I’ve used NVIDIA filters to increase the brightness to compensate, but again, I really only bought this to play competitive games at a high refresh rate. I switch to my PG27UQ 4K monitor for proper GSYNC/visual fidelity
HDR400:
-In comparison to my PG27UQ HDR1000 certificiation, my PG27UQ blows it out of the water obviously.
If this is your first HDR monitor, you’ll still be impressed by the visuals in games that do support it. Just keep HDR disabled in Windows until you’re ready to play a game.
-Windows 11 is also going to be changing how HDR looks when it’s enabled by default so that it doesn’t look washed out when you’re not playing a game or not playing an HDR-capable video
TL;DR:
+Buy it for competitive games, especially if you want ELMB. Buy it if your card can achieve 240fps+
-Don’t buy this if you’re looking for GSYNC compatible features. Most would argue native GSYNC monitors, while expensive, are worth it if you’re a stickler for it. Otherwise, know that you are getting something that is “good” but not as good as actual GSYNC.
-For GSYNC Enthusiasts, look up PG279QM for an actual 1440p 240hz (not 270hz) GSYNC monitor with similar features). Keep in mind, the PG279QM does NOT have ULMB despite having a native GSYNC module. But most reviews seem to praise it despite it and looks good without it.
-Dont buy this for the HDR400. The lowest I recommend is HDR600 for any noticeable difference. It’s still better than nothing, but if you can afford to buy something better, then buy something better.
Sujith –
PREVIOUS MONITOR
Since 2016 I’ve used the Acer XB271HU 1440p, 165Hz, IPS, G-SYNC Module, 27″ monitor for everything I did. That includes gaming, 3D modeling (Rhino3D, Maya, ZBrush), 3D rendering (Maxwell, VRay), photo editing (Photoshop, Lightroom), 2D graphics (Illustrator), and it did great for everything. I never calibrated it and colors were still decently good (not perfect) when printing physical copies of my work. For gaming, it was great and I could not have chosen a better monitor when I did for the various things I needed it for.
NEW MONITOR (ASUS XG27AQM)
To preface this, I’ve also used the Acer XB273U GX and the ASUS TUF VG259QM for several months each and at separate times each. Purchased them at Micro Center just for testing purposes (to see which I liked more) and not for ownership. I know some people prefer 24″ monitors for gaming, but I personally can switch between 24″ and 27″ monitors just fine.
It’s only been one day since I received ASUS XG27AQM in the mail, but listed below are my PROS and CONS. Personally, it’s worth the upgrade from my previous monitor (especially since I’ll be looking to sell my XB271HU now). The ability to feel and play at frames higher than 165fps (especially if sustained and with a crisp frame time graph) is very noticeable and makes fast paced games much more enjoyable. I have not overclocked it to 270Hz because there’s currently really no need to in my opinion (refer to CONS).
SIDE NOTE (UPDATED)
I’m also a bit cautious of the OC function because on my previous experience with the Acer XB273U GX and the ASUS TUF VG259QM. Both screens would go black for a few seconds and then the picture would come back. Granted, it also warns you when enabling the OC. I honestly didn’t mind it, but it’d happen in the middle of a game which was annoying at times. I purchased an iVANKY DP1.4 cable (since the reviews were great) and the black screen still happened even when trying different ports on the monitors and graphics card. The OC function on my Acer XB271HU never caused the screen the go black, ever. Update: Since writing the review, I’ve overclocked the XG27AQM to 270Hz, and at least for my unit, the screen does not flicker or go black for a few seconds. Keeping it overclocked for the foreseeable future.
PROS
– 1440p
– 240Hz (270Hz OC)
– Very Responsive (Slightly quicker input lag than my previous monitor, but that’s probably due to the increase Hz)
– Good colors (Will most certainly calibrate this monitor though)
– Arrived with zero dead pixels
– No perceptible overshoot at Overdrive Setting 4 (I tried OD-5 as well, but I visually preferred OD-4)
– Motion clarity at OD-4 with ELMB disabled is noticeably improved from my previous monitor
– I have G-SYNC Compatible enabled and it works great (I personally don’t notice a difference from a physical G-SYNC Module, and many well documented reviews for monitors only show an input lag increase of <1ms when enabling a Variable Refresh Rate technology) so it's worth it
CONS
– When enabling ELMB, the brightness is too low for me even in a very dark room. Update: I’ve since enabled ELMB. What I did to combat the brightness drop is set it to 100% brightness first, then enabled ELMB, and finally set Shadow Boost to Level 2. It was plenty usable after that.
– I don’t have an RTX 3080 yet to push more frames haha :'( My RTX 2070 Super is great, but an upgrade is definitely needed for this type of monitor. Maybe I’ll wait for an RTX 4080 to pair with my i9-10850K @ 5.0GHz.
FINAL THOUGHTS
If you haven’t purchased a monitor in several years and have been looking for a proper upgrade, here is your monitor, the ASUS XG27AQM. These specs will not become obsolete any time soon. The 1440p resolution provides improved visual clarity from 1080p, the increased refresh rate of 240Hz Native/270Hz OC from 165Hz is noticeable, and the motion clarity improvement is great for the enjoyment of fast paced video games.
If I were asked, “Would you return your ASUS XG27AQM and instead purchase the Acer XB273U GX or ASUS TUF VG259QM?”, my answer would be, “No.”
But if I were asked, “In hindsight, which would you purchase, the ASUS XG27AQM, Acer XB273U GX or ASUS TUF VG259QM?”, my answer would be, “The ASUS TUF VG259QM is 100% out of the question because of the noticeable decrease in resolution and visual clarity. For the ASUS XG27AQM and Acer XB273U GX it would depend on availability. Both 1440p 270Hz monitors are great each with their own pros and cons. The Acer XB273U GX has two usable Black Frame Insertion modes (Off, Normal, and Extreme) vs the ASUS XG27AQM’s (On and Off). Colors, motion clarity, and input lag are all comparable. Ultimately, I’d be hard pressed to say one is better than the other, so I’d be happy purchasing either the ASUS XG27AQM or the Acer XB273U GX. But from my own personal experience, there was some noticeable overshoot on my copy of the Acer XB273U GX which is why I did not repurchase it and instead went for the ASUS XG27AQM. No overshoot to be seen on my copy of the ASUS XG27AQM which is why I will be keeping this monitor and not returning it.”
Games I Play: Witcher 3, PUBG, Rocket League, Battlefield (4, V, 2042), Apex Legends, Risk of Rain 2, Dragon Quest XI, Ori Series, Trine Series, and Resident Evil 2 Remake.
ROBERT –
I ABSOLUTELY LOVE THIS MONITOR!!!!!!! I had a 2k 165hz Dell Monitor before upgrading, and the panel on this is MUCH better. The extra refresh rate is nice, but honestly just the panel is so nice
Casey Evans –
EDIT: I have updated this from 3 star to 4 stars, since using the included DP cable fixed the shutoff/flicker issues, so yeah, cable matters, I’ll get a 3rd party DP 2.0 since this one is a bit too short for me
——–
-Don’t know if this is specific to my unit but sometimes its going to shutdown randomly for 5 seconds(only when in OC mode)
-OC also makes the screen flicker, extremely annoying at times
I will do more research if this could be linked to my display port 1.2 (I’m not using the once included because it is too short) and if this is the case I will edit this listing 🙂
But other than that I guess I’ve got a decent “Used like New” deal for $750(though I still think high HZ monitors are overpriced), looks great and is so much faster than my old one
no dead pixels and little backlight bleeding
To be honest, this monitor is a 4/5 other than the monitor shutting off randomly, these OC issues should have been mentioned in the listing
Azuki –
I took a chance and bought one of these monitors used from Amazon’s Warehouse Deals.
Fast-paced games are finally easier to keep track of, and your view is much less of a massive blur when turning quickly. Your aim doesn’t necessarily get better compared to a 144 Hz monitor, however.
The particular panel I received had virtually zero backlight bleed/IPS glow, but it did have one single stuck pixel on the screen. However, the pixel is so tiny, it is virtually invisible to the eye. (I’ve tried various means to fix the pixel, but to no avail.) Nonetheless, you would never be able to see it unless you REALLY looked for it anyway. (I imagine this was why the previous owner returned the panel.)
I only have two complaints. The first is that the ELMB tends to disable itself when the program or input is changed, so you have to re-enable it every time. The second is that whenever an input is empty, the monitor will always switch to an input that is active, which gets annoying if you are just waiting on a restart or something.
Saving around $80 after tax just for a single unnoticeable pixel was well worth it, in my opinion. Even with this monitor on sale and the new 360 Hz monitors coming out, it would still likely never reach this price for the next long while.
Overall, I am quite content with this monitor, and I recommend it for anyone who only needs ~270 Hz rather than 300+. Grab it on sale, or take your chance with Warehouse Deal stock.
Sujith –
Don’t buy this product…. I bought it and sent it for replacement…now it’s listed renewed..Monitor has bright dot on the top left and monitor beezel are out and accessories are broken….have already added comment to the renewed piece..which I bought it here don’t bu ASUS monitor…SICK of ASUS quality control